LibLab Bookmark

3D Model

Created by: Kat Graves

Creation Date: 2022-07-14

A bookmark with the LibLab logo on the top and LibLab written across the bottom. I used the same logo as the LibLab Medallion, as well as the same collection process. I also used the Blaze Bookmark and cut out both Blaze and the word “libraries” in order to make this one. This project was made in TinkerCAD. The photo was printed on an Ultimaker S5 in green PLA. It took around 25 minutes with an infill of 20% and a layer height of 0.15mm.