Same ScoutCoreXY with 10mm linear rods, twin F694zz bearings for 6mm GT2 belt redirection but some elements of the previous design have been rep-strapped to make use of the remaining 20x10mm Alu Angle used for the bed support.
I have replaced all the passive plastic components used to clamp the ALU square tubes, passive meaning that they were not the other half clamp that has the actual function in the design. Looking at the model you will understand what I mean.
By doing this I am also saving costs for a new build with no other owned machine to print parts on. The 3dhubs are pretty expensive so a major factor for this rep-strap variant is to minimize the amount of plastic parts I have to order.