Triangles: 20.4k
Vertices: 10.2k
More model informationI don’t like getting poked by my wire brush when it’s in my tool bag. Thus I created this so I could leave it hanging on a wall outside of my bag.
It’s not something I use often, so that is why its just a wall mount instead of a “carry case.”
Print setting
-
I think you should print it at 110% because it’s a bit too tight of a fit.
-
10% cubic infill if you want
Mounting
-
I did not include a screw hole, i manually drilled a hole in the back.
-
You can also use doublesided tape
I am the owner of https://www.neocrisis.com/
CC AttributionCreative Commons Attribution
Feb 19th 2019
Comments