3D Scan a fish? Why not? Andy Lewis from Pot80Sh3D did just this as part of his promotion design for the British band Shriekback. This photo made my week 😉
Based on this scan, fellow Sketchfab community member Wojtek Grabczak created the following 3D printed fish model:
Shriekback Sea Bream Rev5
by Pot8oSh3D
on Sketchfab
Andy then went on to scan the band:
Shriekback; A 3-headed creature with one….
by Pot8oSh3D
on Sketchfab
The limited edition of 50 copies sold out in 50 hours!
Read the full story on the Shriekback blog and on 3DPrint.com.
– Bart