a simple webcam stand with 2 parts (CAGE, STAND) which i created for my Ultimaker3 (maybe works with other models too? plz let me know!). The built in Webcam is nice, but i wanted an additional one on the top for streams.

So this one is put on the edge of the printer with 2 slots on the back (cage) for wires.

!!! It has a large 50° angle, because otherwise i wouldn't get a nice picture of the whole printing plate. So be careful that your webcam does not fall down into the printer. Check before use, WARRANTY EXCLUDED! Use a tape or sth if u need it to be fixed! ;)

**GLUE** THE CAGE TO THE STAND AT THE POSITION YOU PREFER, IT DOES NOT STICK TOGETHER BY ITSELF!!!

The smalll hole on the bottom fits to the STAND.

printed with:

0.2mm resolution

20% infill

support YES

50mm/s speed

Download and try for free! :D

HF