Tiled Stove - Revopoint Trackit

3D Model

Scanning

Scanning was done at 2mm target resolution and no scan spray was used. I was to lazy to calibrate the Trackit so some of the surface quality defects may be accountable to this problem. Tracking quality was indicated as poor so time to calibrate. Scan was performed in three parts (could have been two but the first placement of the tracker was suboptimal) and each scan consists of paint brush movements until full data quality was reached.

Post-Processing

Processing work was minimal by first fusing at 1mm (software even recommended 0.75mm) and then aligning the partial scans to one whole scan. Meshing was done at recommended settings and alignment to the coordinate system with Quicksurface.